APOLLO Corrosion Resistant Elbow Support Bracket Bolt-on Design for W195 W205 W215 Milling Machines

This corrosion resistant elbow support bracket, part number 2053061, holds bent pipes and hydraulic elbows steady on W195, W205 and W215 cold milling machines. The bracket clamps the elbow in a curved saddle and bolts straight onto the machine frame, so the pipe keeps its routing angle and stops working against its own fittings. When a bracket cracks or its bolts loosen, the elbow starts to move: hose ends leak, the pipe fatigues at the bend and the machine drops out of service at the worst time. This is the part that stops that chain of failures before it starts.

• Holds the elbow at its designed angle, so the pipe runs true from the pump to the consumer
• Curved saddle spreads clamping load along the bend instead of pinching the tube at one point
• Stops the elbow from drifting when hoses are replaced or couplings are tightened

• Reduces vibration transfer from the machine frame into the pipe joint, the main cause of weeping fittings
• Removes repeated bending stress at the elbow - the point where hydraulic and lubrication lines usually fail first
• Keeps fittings seated so pressure spikes act on the hose, not on a half-supported joint

• Corrosion resistant steel with anti-corrosion coating - holds up to water spray, dust and road salt
• No rust jacking under the bolt heads, so the bracket can still be removed at the next service
• Suitable for machines working in wet cutting, dust suppression and coastal contracts

• Bolt-on design: remove two fasteners, swap the bracket, torque and go
• Original mounting dimensions, no drilling, no welding, no repainting of the frame
• Fits all three models W195, W205 and W215, which simplifies stock for mixed fleets

• Replacing a cracked or bent elbow support bracket after impact damage
• Fixing loose pipe supports that cause hydraulic weeping at the joints
• Scheduled replacement during undercarriage or hose servicing
• Fleet maintenance across mixed W195 / W205 / W215 milling spreads
• Refurbishment of used machines before resale

• Check bracket bolts at every service; vibration loosens them gradually rather than all at once
• Inspect the saddle for deformation after any impact to the pipe run
• Wash salt and abrasive dust off the bracket during machine cleaning
• Replace brackets in pairs where the pipe run is symmetrical

Send us the part number, machine model and quantity, and our Suzhou team will confirm fitment, quote the best price and arrange shipment within the lead time above.