APOLLO 108756 Poly Track Pad Kit Pre-Assembled Undercarriage Assembly for W1500 W1900 Road Milling Machines

APOLLO 108756 Poly Track Pad Kit, Pre-Assembled for W1500 / W1900

Undercarriage work is the slowest maintenance job on a road milling machine. If pads and chain are ordered separately, the crew spends the first day pressing pins, aligning links and rebuilding the assembly on the floor before the machine can even be lifted. The APOLLO 108756 poly track pad kit removes that step: pads and steel chain rails arrive already assembled as one unit, matched to the W1500 and W1900 track frame.

Part number 108756. Fits W1500 and W1900. Pre-assembled and ready to install. That is the whole proposition — one lift, one fit, back to milling.

Ready to Install, Not Ready to Assemble

The kit is supplied as a complete integrated unit rather than a box of loose components. In practice this changes the job from a rebuild into a replacement:

1. Machine on stands — track slackened and the old assembly lowered out.
2. New kit lifted in as one piece — no pin pressing, no link matching, no pad bolting on the workshop floor.
3. Track tensioned and run in — the machine is back on the cut, typically within one shift.

Because the assembly is pre-built and pre-aligned, the risk of a mis-seated pin or an incorrectly torqued pad — the two most common causes of early undercarriage failure — is removed from the equation.

Polyurethane Pads vs Rubber

On milling work the pads contact milled asphalt, water spray, diesel spill and abrasive fines all day. Polyurethane holds up better than conventional rubber in exactly these conditions:

• Tear resistance — resists chunking and edge tearing on sharp milled surfaces.
• Hydrolysis resistance — does not degrade in continuous wet operation with dust suppression running.
• Oil resistance — tolerant of fuel and hydraulic fluid spill around the machine.
• Higher hardness — stiffer footprint for a heavy milling machine without excessive squirm.

Kit Contents and Specification

Planning the Replacement

Measure pad wear across the full track before ordering. Uneven wear concentrated on the drive end usually indicates a tension or alignment issue that will destroy a new kit quickly if left uncorrected. Check idler and sprocket condition at the same time — a worn sprocket accelerates chain wear on a fresh assembly.

Ordering

Confirm fitment by sending the machine model, serial number and a photo of the current track assembly. Orders can be consolidated with other milling machine undercarriage and conveyor parts for the same shipment.

Request a quote today for the APOLLO 108756 pre-assembled track pad kit.