APOLLO 85010902 Road Milling Teeth Holder BM2000 Milling Machine 20mm Bore Alloy Steel For Replacement

Direct replacement tooth holder for the BM2000 milling drum - heat-treated alloy steel body with a 20mm bore, machined to seat a round-shank tooth square under full cutting load.

The 85010902 tool holder is the part that clamps each milling tooth to the drum on BM2000 road milling machines. When the bore wears oval the tooth starts to rotate in its seat, milling depth drifts across the drum and teeth are lost mid-pass. Replacing the holder together with the tooth set restores a firm clamp and brings the cutting geometry back to specification.

• Referenced to 85010902 / 85001092 - the same part number family used across BM2000 milling drums, so it drops into the existing seat.
• Heat-treated alloy steel body - surface hardening for wear resistance while the core keeps the impact toughness a tooth holder needs.
• 20mm precision-machined bore - holds a round-shank tooth square, so it cuts at the designed angle instead of chattering.
• Flat, true locating face - pulls down against the mounting face without shimming or re-machining.
• Direct fit, no modification - no welding, no adaptor plate, no change to the drum layout.

• The tooth turns freely in the bore or drops out when the drum stops.
• The bore shows an oval, polished or hammered wear pattern.
• The holder body is cracked, deformed or has lost its locating face.
• Teeth are being lost during the cut, forcing repeated stops to refit.
• Milling depth is uneven across the drum even with a fresh tooth set.

1. Isolate the machine and lock out the drum before starting.
2. Clean the mounting face and bore seat so the new holder pulls down flat.
3. Seat the holder square and torque the fixing to the machine manufacturer's figure.
4. Fit the tooth and confirm it rotates in the bore but cannot be pulled out by hand.
5. Run the drum briefly at low load and re-check torque before full cutting depth.

Holders ship from stock at a minimum order of 50 pieces, boxed or packed as agreed, dispatched 7-10 days after payment and payable by L/C or T/T. Monthly capacity is 10,000 pieces, enough to cover a full fleet tooth and holder change-out through a milling season.

Send the machine model, drum layout and a photo of the existing holder and the parts team will confirm the fit before shipment.