APOLLO RM54426663 6 Pin Data Cable Socket Plug Waterproof Screed Harness Connector

Weatherproof connector that keeps screed control signals intact through rain shifts, dust and hot-mix conditions

• Sealed housing against site conditions — water, dust and oil are kept out of the contact block, which is where most intermittent screed faults start.
• Six contacts, straight-through wiring — replaces the failed plug without cutting, crimping or re-terminating the harness.
• Positive locking tab — resists the vibration that works loose push-fit connectors on a running paver.
• Left and right screed sides — the same plug serves both harness distributors, so one part number covers the pair in a service kit.
• Correct RM54426663 reference — cross-checked against the ABG screed harness layout before dispatch.

• Screed heating drops out on one side, then returns after the machine is restarted
• Temperature or sensor readings jump instead of holding a steady value
• Errors appear after rain, wash-down or a long hot shift
• Wiggling the harness at the distributor changes the fault

If the fault follows the harness movement, the plug is the first item to swap. Start there before replacing modules upstream.

Isolate the machine and disconnect the battery before opening the distributor cover. Release the locking tab, withdraw the plug by the body rather than by the cable, and check the contact block for bitumen or corrosion. Seat the replacement until the tab clicks, confirm the sealing ring sits flush, then run the screed heat cycle and a sensor readout test before returning to the job.

Single pieces and fleet quantities are both supplied, with dispatch 1–2 weeks after payment, packing in a carton with anti-static bag and foam insert, and payment by L/C, T/T or Western Union. Send your screed model and the number moulded on the old plug and our parts team will confirm the fit before shipment.