APOLLO Water Nozzle 2027825 High-Pressure Spray Nozzle Plastic Replacement FOR Road Roller MACHINE

This 2027825 water spray nozzle is the replacement part for the drum water-spray system on tandem and single-drum road rollers. It delivers a flat, evenly spread spray pattern across the drum surface instead of the uneven jetting that worn nozzles produce, which is what causes patchy wetting, material pick-up and streaking on the finished mat.

The body is moulded in engineering plastic with a machined spray orifice, giving a balance of corrosion resistance against emulsion and water additives, low weight, and repeatable spray geometry across a full set of nozzles. Each unit is a push-fit replacement for the original 2027825 position, so a full bar can be renewed during a routine service without modifying the spray pipe.

• Uneven drum wetting - a consistent fan pattern keeps the full drum width at the same moisture level, reducing pick-up and surface tearing.
• Blocked or dribbling orifices - clean internal passage restores flow and stops the constant drip that wastes water and marks the mat.
• Water and additive waste - correct spray geometry means the pump runs less to wet the same area, extending tank intervals during a shift.
• Downtime during a paving window - nozzles are a small, low-cost part that stops the machine when the drum starts to pick up, so keeping a spare set on board is standard practice.

Monthly supply capacity is 10,000 pieces, which supports both single-unit service orders and fleet-wide nozzle renewal programmes. Payment is accepted by L/C or T/T, and orders ship in protective boxes by air or sea freight.

For contractors running several rollers, the practical approach is to replace the full nozzle bar at the same time rather than one unit at a time. Mixed old and new nozzles give an uneven pattern that is often mistaken for a pump or filter fault, and a full bar replacement takes minutes compared with diagnosing individual units.

• Switch off the engine and release pressure from the spray system before removing nozzles.
• Flush the spray bar to clear scale and debris left from the old units.
• Check the filter screen and pump strainer while the bar is open.
• Press each 2027825 nozzle fully home and confirm it is seated square to the bar.
• Run the system and check the fan pattern across the drum width before starting work.

Send the part number 2027825, the quantity you need for your fleet, and the destination port. We will confirm stock, freight cost and the shipment date the same working day.