New Corrosion Resistant Elbow Support Bracket for W195 W205 W215 Milling Machines Now in Stock

A corrosion resistant elbow support bracket for W195, W205 and W215 cold milling machines is now available from stock in Suzhou, Jiangsu, China. The bracket carries part number 2053061 and clamps bent pipes and hydraulic elbows in place on the machine frame.

Pipe brackets rarely get attention until something leaks. When a bracket cracks or its bolts work loose, the elbow starts to move with every vibration cycle. The fitting weeps, the tube fatigues at the bend, and the fix turns into a hose replacement at a bad moment. This bracket is the cheap part that prevents the expensive repair.

Elbow support bracket 2053061, bolt-on design with curved saddle

What the bracket does

The unit bolts onto the frame and holds the elbow in a curved saddle, so the pipe keeps the routing angle it was designed for. Three things follow. Vibration from the machine frame stops travelling into the fitting. The bend no longer flexes under pressure spikes. And the pipe stays clear of moving components during operation and maintenance. On machines used for wet cutting or dust suppression, a coated steel bracket also means the fasteners can still be removed at the next service instead of shearing off in a rusted hole.

Specifications

Design details

• Curved saddle, not a flat clamp. Clamping load is spread along the bend instead of pinching the tube at a single point.
• Corrosion resistant steel with coating. Holds up to water spray, abrasive dust and road salt without rust jacking under the bolt heads.
• Original mounting dimensions. The bracket drops onto the existing holes, so no drilling, no welding and no repainting of the frame.
• One part for three models. The same bracket serves W195, W205 and W215, which keeps stock simple for mixed fleets.
• Service friendly. Two fasteners out, new bracket in, torque and back to work.

Close-up of the saddle and bolt holes: load spread along the elbow bend

Installation notes

• Depressurise the hydraulic circuit, support the pipe and clean the mounting face before removal.
• Reuse the original bolts if they are serviceable; replace any that are stretched or corroded.
• Check that the elbow sits in the saddle without pre-load once the bolts are torqued.
• Confirm the pipe runs clear of moving parts through the full travel of the machine.
• Re-check bolt torque after the first shift, then at each service interval.

Availability and ordering

Where it is used

The bracket is ordered most often for three situations: replacing a unit bent or cracked after impact, fixing a pipe run that keeps weeping at the joints because the support has loosened, and scheduled replacement while hoses are being serviced. Refurbishers also fit them when preparing used W195, W205 and W215 machines for resale.

Because the bracket is small and light, it ships economically with other spare parts such as spray nozzles, heating rods and track shoe kits on one consolidated order. Neutral packaging is available for dealers who stock under their own label.

Order part 2053061

Send us the part number from the old bracket, the machine model and the quantity required. Brackets differ between pipe positions on the same machine, so a photo of the installed bracket is often the fastest way to confirm the correct item. Our Suzhou team replies the same working day and dispatches stock orders within the lead time above.

Contact our spare parts team for pricing and stock availability on the 2053061 elbow support bracket.