APOLLO 2480135 Screed Connecting Cable for S1800-3i Asphalt Paver Back in Stock

Electrical faults on the screed side of an S1800-3i asphalt paver often trace back to one inexpensive item: the connecting cable that carries power and signals between the screed and the main machine. The APOLLO 2480135 cable assembly is now available from stock as a complete unit with the machine-end plug fitted.

The Weakest Link Moves Most

The screed is raised, extended and folded every working day, and the cable has to follow all of that movement across the tow arms and through the working joint between the two assemblies. Thousands of flex cycles later, the conductor bundle inside the jacket starts to fatigue and the plug pins take the rest of the punishment. The result is not usually a clean break. It is an intermittent fault that appears only at a particular paving width or after the screed has been folded.

Replacing the cable as a complete assembly removes the guesswork. There is no crimping on site, no terminals to source, and no risk of a partially repaired harness failing again mid-shift.

Key Features

• Complete assembly with plug: machine-end connector fitted at the factory, ready to route and connect.
• Correct routing length: dimensioned for the S1800-3i so the cable follows the original path without tension at either end.
• Flex resistant build: jacket and conductor bundle rated for repeated movement at the screed pivot.
• Stable signal path: maintains continuity for screed control and sensor signals under vibration and heat.
• Genuine APOLLO spare: produced to original specification for repeatable fit and service life.

Technical Overview

Diagnosing Before Replacing

Before ordering a control unit, run a continuity check along the cable with the screed moved through its full travel. A cable that tests fine when static but loses continuity when the screed extends is already the answer.

• Functions that drop out only at a specific paving width.
• Readings that jump or freeze and clear after a restart.
• Cracked jacket, exposed conductor, or green corrosion at the plug pins.
• Fault codes that disappear when the connector is moved.

Supply and Ordering

Each cable is packed in a carton with protective packing for export. Minimum order quantity is one piece, which suits a single repair as well as stock keeping for a service fleet. Payment terms include L/C, T/T and Western Union, and delivery is normally one to two weeks after payment.

Please confirm the machine model S1800-3i together with part number 2480135 when inquiring. Photographs of the original cable, especially the plug and any label, are welcome and will be checked against stock before shipment. For pricing, lead time and combined orders of paver spare parts, contact our sales team.