Apollo 6 Pin Socket Plug RM54426663 Added for ABG Paver Screed Harnesses

The 6 pin data cable socket plug, part number RM54426663, is now held in stock for the wire harness distributor on both sides of the ABG paver screed. The plug carries a sealed housing and a positive locking tab, addressing the two failure modes that take screed heating and sensor circuits offline mid-shift: water ingress and vibration loosening the joint.

The distributor on the screed is the least sheltered electrical joint on the machine. Bitumen mist settles on it, wash-down water reaches it, and the paver vibrates continuously while the screed is heating and floating. A push-fit connector that has lost its seal admits moisture into the contact block; a connector that has lost its locking tension backs out a fraction of a millimetre under vibration. Both produce the same symptoms: heating drops out on one side, sensor readings jump, and the error clears after a restart — until it does not.

Because the fault is intermittent, it is often misdiagnosed as a module problem upstream. The practical diagnostic is simple: if moving the harness at the distributor changes the fault, the plug is the first item to replace, and it is also the cheapest.

• Sealed housing — water, dust and oil are kept out of the 6-pin contact block.
• Six contacts, straight-through wiring — no cutting, crimping or re-terminating the harness.
• Positive locking tab — holds the joint under continuous paver vibration.
• Left and right screed sides — one part number covers the pair in a service kit.
• Correct RM54426663 reference — cross-checked against the ABG screed harness layout before dispatch.

Isolate the machine and disconnect the battery before opening the distributor cover. Release the locking tab, withdraw the plug by the body rather than by the cable, and inspect the contact block for bitumen or corrosion before fitting the replacement. Seat the new plug until the tab clicks, confirm the sealing ring sits flush against the housing, then run a screed heat cycle and a sensor readout test before the paver returns to work.

• Screed heating drops out on one side and returns after a restart
• Temperature or sensor readings jump instead of holding steady
• Errors appear after rain, wash-down or a long hot shift
• Wiggling the harness at the distributor changes the fault

Single pieces and fleet quantities are both supplied, packed in a carton with an anti-static bag and foam insert, dispatched 1–2 weeks after payment, with payment by L/C, T/T or Western Union. Buyers are asked to send the screed model and the number moulded on the old plug so the fit can be confirmed in writing before shipment.